Fine-tunes the alignment of already placed components to maximize routing channels and printed-circuit board real estate, using the following criteria:
- Components must exist on the same subclass.元件必須在同一類，同一層
- More than one component must be chosen. 對象數目必須1個以上
- Components must not have the FIXED property assigned to them. 元件沒有固定屬性
Available only in the Placement application mode, this command functions in a pre-selection use model, in which you choose at least two components first, then right click on the component you want to serve as the reference and execute the command.
1，選中Setup->Placement application mode
2,選中需要對齊的所有對象
3，右鍵點擊參考對象，或者在空白處按住Shift 右鍵單擊，彈出菜單中選擇Align component.
注意，如果元件散落成X,Y方向都有可能對齊的樣式，軟件會選擇其中不會造成Align 后元件重疊的那種方向進行對齊。
本站僅提供存儲服務，所有內容均由用戶發布，如發現有害或侵權內容，請
點擊舉報。
